Yes

• Max Values - A measure of the best performance and probability that can be achieved.

• Back-Test - A measure of the average performance at 100% probability.

• Trade Mode - Directs the user when to open and close a position.

By referring to the Long & Short Probability and the Long & Short VAR (Value at Risk). Other important values are Expected Profit, Win-Rate and Total Profit.

The spread is automatically calculated and the commission is manually entered into the Inputs.

Check Type (Inputs) for Forex selected. Increase the Forex Units.

• Single Confirm Buy - When %K and %D cross and are above Overbought (or below Oversold) then a Buy signal is issued.

• Double Confirm Buy - When the %K crosses below the Overbought (or above the Oversold) and %D is above the Overbought (or below the Oversold) then a Buy signal is issued. This is often a less profitable strategy but safer.

Both stratigies should be verified in the Back-Test Mode.

Change the Trend Alert to Alert On.

A measure of the trend strength.

Yes, change Show Absolute True Strength to ATS_10x, ATS_100x, ATS_1000 or ATS_10000x. This is a very important leading indicator for change in trend direction.

Is a measure of the risk of investments based over a time period. For this application, it is the percent of time that the trade showing a loss.

Yes, you can plot the total VAR, the long or short VAR.

The Average True Range (ATR) is a measure of volatility. APTR is the the ATR converted to a percentage for comparing different stocks on the same scale.

Yes, change Show APTR to APTR_10x, APTR_100x or APTR_1000x.

Yes, change Use Limits to Auto or Fixed. The auto sell limit is calculated a 1 x APTR and the stop limit is calculated at 3 x APTR. The fixed limits are adjustable.

Yes, change the Stock Dollars to the new amount.

Yes, change Forex Units to the desired amount.

Yes, change the Trade Commission to the desired amount.

A Absolute True Strength algorithm to reduce false buy signals. The filter is off when set to 0.

By selecting the Max Values Mode and adjust the %K Period, %D Period and the Slowing Periods. Also try different Smoothing Type settings.

Yes, change Show Tick Counter to yes.

Yes, change to yes.